Installing vinyl planks over concrete requires that the floor be level within a 10′ radius, with the standard tolerance being 3/16″. A dip of 1/8″ within 2 feet is also prohibited. There is no incline in any direction on a leveled floor.
Table of Contents
Can you install vinyl plank flooring on an uneven floor?
Even on uneven surfaces, vinyl flooring performs admirably. Vinyl planks can be installed on uneven floors. If you’re installing vinyl flooring, you’ll need to make sure the subfloor is clean and level before proceeding. In some cases, a sanding or self-leveling compound will be required.
How smooth should subfloor be for vinyl planks?
There must be no slope greater than 12 inch per 6 feet in the subfloors (25 mm per 1.8 m) Maintain a sound structural foundation.
Does vinyl plank need to be flat?
In order to install vinyl plank floors, the only requirement is that the floor’s surface be level. A floor can be flat and have a plane to it, so it isn’t critical that it be level. The installation surface must be flat and free of debris before a floor can be installed for the first time.
Does floor need to be level for vinyl flooring?
But, just like with any other permanent product, it’s imperative that the existing floor is clean and dry, in excellent condition, and most important, level. In order to avoid uneven heights in the adjacent vinyl plank flooring, you need a level and flat floor.
Do you need a subfloor for vinyl plank flooring?
There is a need for an underlayment even with waterproof vinyl planksThat’s correct! An underlayment can benefit almost any type of flooring. This is not just a water vapor barrier; it also reduces noise and adds insulation.
Does underlayment have to be perfectly flat?
The subfloor must be perfectly flat and featureless: no nails, screws, bumps, or dips.
How flat should a subfloor be?
The standard specifies that a concrete subfloor must be flat. The subfloor, or ‘underfloor’ as I like to call it, “shall not deviate more than 3/16 of an inch in ten feet.” Using a ten straight edge, the floor’s undulation can be measured in photo 1.
How flat does subfloor need to be for laminate?
A 10 foot radius should have a flat floor within 3/16″ of the manufacturer’s recommended flatness. Measurements like these are common across a wide range of flooring options. Vertical movement must be minimized on floating floors.
How flat Do floors need to be for luxury plank?
A tolerance of 3/16″ in a 10′ radius is required for the floor’s flatness. Concrete Slab, Sheet Vinyl, Ceramic Tile, CDX Grade Plywood, OSB (3/4″ Min), Underlayment grade Particleboard, and existing Hardwood or Laminate floors are all acceptable substrates for the installation of a new flooring.
How do you level a floor before installing vinyl plank flooring?
Using a trowel, apply the floor leveler to the subfloor and level it out. As it descends, gravity will aid in its movement. Get rid of any extra floor leveler, then feather the edges to make them blend in. Drying time for the floor leveler depends on the manufacturer.
